TM 5-3895-373-34
2.43
REPLACE/REPAIR AUXILIARY VIBRATION PUMP - Continued
B.
DISASSEMBLE - Continued.
NOTE
Gear set matchmarks are required
for proper meshing of gear teeth
upon assembly when reusing gear
set.
f.
Use marker to matchmark shaft ends at
front end of housed gear and bearing set.
g.
Lay pump housing (17) on its side with
drive gear shaft on the left, as shown.
h.
From rear of pump housing (17), push
bearing and gear set part way out of pump
housing.
i.
Use marker to mark F (front) and S (shaft)
reference marks on front of pump housing
(17) and bearing and gear set. These
marks will be used on reassembly.
j.
Use marker to mark R (rear) and S (shaft)
reference marks on rear of pump housing
(17) and bearing and gear set. These
marks will be used on reassembly.
k.
Push bearing and gear set out of pump
housing (17).
2-588
