TM 5-3895-373-34
A.
REMOVE - Continued.
3.
REMOVE FLANGE AND RING SEAL.
a.
Stand speed reduction gearbox (8) on end,
with installed brake (10) up. Use scribe or
marker to matchmark mating flanges of
brake and gearbox. Also, place a pair of
matchmarks along main body of gearbox,
one wide and one narrow.
NOTE
Spline
coupling
(11)
may
have
remained on propulsion motor drive
shaft during motor removal.
b.
Remove spline coupling (11).
Use care when removing snap and
retaining rings. Snap and retaining
rings are under spring tension and
can act as projectiles when released
and could cause severe eye injury.
c.
Use snap ring pliers to remove retaining
ring (12) from spline coupling (11). Discard
retaining ring.
d.
Remove bolts (13). Use plastic hammer to
loosen flange (14) from its seating surface.
Remove flange.
e.
Remove and discard gasket (15).
f.
Use plastic hammer to drive ring seal (16)
from flange (14). Discard ring seal.
GO TO NEXT PAGE
2-473
