3. REMOVE PROPULSION PUMP

2. DISCONNECT ELECTRICAL CONNECTIONS AND HYDRAULIC HOSES FROM LEFT PROPULSION PUMP

2. REMOVE HYDRAULIC FITTINGS FROM RIGHT PROPULSION PUMP

TM-5-3895-373-34 Paving Machine Bituminous Material Crawler Mounted Diesel Engine Driven Manual
Page Navigation
422

TM 5-3895-373-34 2.30 REPLACE/REPAIR PROPULSION PUMP - Continued. A. REMOVE Continued. 3. REMOVE PROPULSION PUMP. Propulsion pump weighs 75 lbs (34 kg). Place cribbing beneath pump prior to removal from pump drive gearbox. Damage to equipment and personnel injury may result from unexpected movement of propulsion pump. NOTE Procedures for removing the left and right propulsion pumps are identical. The right propulsion pump is illustrated in this procedure; perform the same steps for the left propulsion pump. a. Remove lower hex head cap screw (19), lockwasher (20), and flat washer (21) securing propulsion pump to pump drive gearbox. Discard lockwasher. b. Place cribbing beneath propulsion pump (22). c. Remove upper hex head cap screw (19), lockwasher (20), and flat washer (21) securing propulsion pump to pump drive gearbox. Discard lockwasher. d. Pull propulsion pump (22) from pump drive gearbox (23) and position onto cribbing. e. With the help of another person, lift propulsion pump from cribbing and out of engine compartment. f. Remove gasket (24) from pump drive gearbox (23). Discard gasket. NOTE Adapter gear sleeve may come out of pump drive gearbox with propulsion pump. If adapter gear sleeve is removed, replace adapter gear sleeve " into pump drive gearbox. g. Place propulsion pump on a clean work surface. GO TO NEXT PAGE 2-398

Privacy Statement
Press Release
Contact