TM 5-3895-373-34
C.
ADJUST.
1.
ADJUST
CONFIGURATION
OF
NEW
FUEL
LEVEL TRANSMITTER.
a.
Remove adjustment screws (42), lockwasher
(43), and hex nut (44). Discard screws.
b.
Separate upper adjustment bracket (45) from
lower adjustment bracket (46).
c.
Remove screws (47) from float control head
(48) and remove from lower adjustment
bracket (46). Discard lower adjustment
bracket.
d.
Slide float control head (48) onto upper
adjustment bracket (45) as shown.
e.
Install screws (47) but do not tighten at this
time.
2.
ADJUST FUEL LEVEL TRANSMITTER.
a.
Adjust distance between bottom of fuel level
transmitter flange and pivot point of float lever
to 6.5 in. (165 mm).
b.
Tighten screws (47).
3.
ADJUST FLOAT LEVER.
a.
Loosen set screw (49). Remove shipping pin
(50) from pivot point. Discard pin.
b.
Install float lever. Adjust float lever to 7.25 in.
(184 mm) between center of pivot point and
curved end of float lever with float ball
positioned as shown.
c.
Tighten set screw (49).
d.
Trim excess length of float lever, leaving 1 in.
(25 mm) from pivot point to end of float lever.
GO TO NEXT PAGE
2-313
