TM 5-3895-373-34
2.16
ENGINE REPLACEMENT - Continued.
C.
INSTALL Continued.
Ensure the correct size and length
hex head cap screws are used for
installing engine mounting brackets
back onto engine. Failure to do so
may result in serious engine damage
if proper cap screw size and length
are not used.
I.
Install lockwashers (223) onto hex head cap
screws (222).
Thread locking compound can cause
eye
damage.
Wear
safety
goggles/glasses when using. Avoid
contact with eyes. If compound
contacts eyes, flush eyes with water
and get immediate medical attention.
NOTE
Threads of hex head cap screw (196)
located
on
right
front
engine
mounting bracket (195) upper left
corner does not get coated with
thread
locking
compound
until
engine ground wire (198) is installed.
m.
Coat threads of hex head cap screws (222) with
thread locking compound. Do not coat threads
of hex head cap screw (196) to be installed in
upper left comer of right front engine mounting
bracket hole.
n.
Install hex head cap screw (222) with
lockwasher (223) and hex head cap screw (196)
with lockwasher (197) into left and right hand
front engine mounting brackets (195).
o.
Tighten hex head cap screws (222) 66 lb-ft (90
N•m). Do not tighten hex head cap screw (196)
installed in right front engine mounting bracket
(195) upper left corner. Tighten this cap screw
finger tight.
GO TO NEXT PAGE
2-116
