TM 5-3895-373-34
A.
REMOVE Continued.
h.
Remove hex head cap screws (213) and
lockwashers (214). Discard lockwashers.
Pump
and
gearbox
weigh
approximately
410
lbs
(187
kg).
Ensure chain assembly and sling
strap are in good condition and are of
correct capacity. Ensure sling strap
is positioned between pump drive
gearbox and flywheel housing. Chain
assembly must be attached securely
to front lifting bracket. Failure to do
so may result in the engine and pump
assembly shifting causing equipment
to fall. This may cause serious injury
or death to personnel.
Do not allow engine and pump
assembly to swing free from hoist
during
removal
from
the
paving
machine.
Engine
and
pump
assembly may strike personnel and
cause serious injury or damage to
machine if allowed to swing free.
Two additional personnel are needed
to help guide the engine and pump
assembly out of the machine during
removal.
i.
Using overhead hoist and two persons on either
side of the pump drive gearbox (185), pull pump
drive gearbox away from engine. Place cribbing
beneath the pump drive gearbox and hydraulic
pumps (215) as shown.
NOTE
Drive shaft (216) may stay attached to
the drive plate (218), or it may come
off with the pump drive gearbox
(185).
j.
Remove drive shaft (216).
k.
Remove socket head cap screws (217) and
drive plate (218) from engine flywheel assembly
(219).
I.
Remove chain assemblies (187 and 212) from
lifting shackles (205) and hex head screw caps
(211). Do not remove lifting shackles or screw
caps.
GO TO NEXT PAGE
2-109
