TM 5-3895-373-34
2.16
ENGINE REPLACEMENT - Continued.
A.
REMOVE Continued.
39.
REMOVE PUMP DRIVE GEARBOX AND
HYDRAULIC PUMPS, DRIVE SHAFT, AND
DRIVE PLATE. INSTALL ENGINE ONTO AN
ENGINE STAND.
a.
Attach two 1/4 in. lifting shackles (205) to lift
brackets (206) on left and right propulsion
pumps (207 and 208).
b.
Attach chain assembly (187) hooks to throats of
lifting shackles (205).
c.
Attach overhead hoist hook (189) to lifting center
of chain assembly (187).
d.
Remove hex head cap screws (209) and
lockwasher (210) on both left and right pump
drive
gearbox
support
brackets.
Discard
lockwasher. Set aside hex head cap screw for
reinstallation.
e.
Install two hex head screw caps (211) into empty
screw holes on pump drive gearbox support
brackets. Screw screw caps in 2 in. leaving 2 in.
remaining out.
f.
Attach chain assembly (212) lifting hooks to hex
head screw caps (211).
g.
Attach overhead hoist hook (189) to lifting center
of chain assembly (212). Take up slack in chain
assembly.
GO TO NEXT PAGE
2-108
