TM 5-3895-373-34
A.
REMOVE Continued.
37.
DISCONNECT ENGINE AND PUMP ASSEMBLY
FROM MOUNTS. LIFT ENGINE AND PUMP
ASSEMBLY FROM THE PAVING MACHINE.
Engine and pump assembly weigh
approximately 2, 000 lbs (908 kg).
Ensure chain assembly and sling
strap are in good condition and are of
correct capacity. Ensure sling strap
is positioned between pump drive
gearbox and flywheel housing. Chain
assembly must be attached securely
to front lifting bracket. Failure to do
so may result in the engine and pump
assembly shifting causing equipment
to fall. This may cause serious injury
or death to personnel.
a.
Guide sling strap (184) between pump drive
gearbox (185) and flywheel housing (186).
b.
Attach chain assembly (187) to front engine
lifting bracket (188) and to the loops on sling
strap (184).
NOTE
Use
the
sling
strap
and
chain
assembly to support the engine and
pump assembly against shifting
while removing the engine and pump
assembly mounting hardware. Take
up
slack
while
the
mounting
hardware is being removed. Do not
raise up on the engine and pump
assembly. This will put added stress
on the mounting hardware making
removal difficult.
c.
Attach overhead hoist hook (189) to the lifting
center of chain assembly (187). Take up slack
in chain assembly and sling strap (184), but do
not raise up on the engine and pump assembly
(190).
GO TO NEXT PAGE
2-103
