TM 5-3895-373-34
2.71
REPLACE MAIN AND EXTENSION SCREED PLATES.
This task covers:
a.
Clean
b.
Remove
c.
Inspect
d.
Replace
INITIAL SETUP
Tools:
Personnel Required:
General mechanic’s automotive tool kit
Three 62B construction equipment repairers. Second and third
(Item 106, Appendix D)
person to assist in screed plate removal and replacement.
C-clamps, 3 ea. (Item 30, Appendix D)
Outside micrometer (Item 15, Appendix D)
References:
Pry bar (Item 9, Appendix D)
TM 5-3895-373-10
Spacer wedges, 6 ea. (Item 22, Appendix C)
TM 5-3895-373-20
Straightedge (Item 27, Appendix C)
TM 5-3895-373-24P
Torque wrench (Item 132, Appendix D)
Wire scratch brush (Item 13, Appendix D)
Equipment Condition:
Endgates removed per
TM 5-3895-373-10.
Materials/Parts:
Main screed cover plates removed per TM 5-3895-373-20
Cleaning cloth (Item 6, Appendix B)
if replacing main screed plate.
Cleaning solvent (Item 31, Appendix B)
Self-locking nuts
NOTE
This
procedure
describes
the
removal of all screed plates. Use
only those steps required to remove
the
screed
plate
requiring
replacement.
A.
CLEAN.
1.
START PAVING MACHINE ENGINE. RAISE
SCREED TO FULL HEIGHT. FULLY EXTEND
EXTENSION SCREEDS. CLOSE SCREED
TRAVEL LOCK VALVE. SHUT OFF ENGINE
AND REMOVE KEY FROM IGNITION SWITCH
PER TM 5-3895-373-10.
GO TO NEXT PAGE
2-1021
