TM 5-3895-373-20
A.
REMOVE Continued.
3.
REMOVE ELBOWS.
a.
Loosen lock nut (9) of elbow (10). Remove
elbow and preformed packing (11). Discard
preformed packing.
b.
Loosen lock nut (12) of elbow (13). Remove
elbow and preformed packing (14). Discard
preformed packing.
B.
INSTALL.
1.
INSTALL ELBOWS.
Hydraulic
oil
can
be
moderately
flammable and can be an irritant to the
skin, eyes, and respiratory system.
Avoid
prolonged
exposure.
Eye
protection and rubber gloves must be
worn when working with hydraulic oil.
Use caution when installing preformed
packings over screw threads. Threads
can
cut
and
damage
preformed
packings.
Ensure
threads
do
not
damage
preformed
packings
during
installation.
a.
Lubricate preformed packings (11 and 14) with
clean hydraulic oil. Install preformed packings on
elbows (10 and 13).
b.
Install elbows (10 and 13) until preformed
packings (11 and 14) seat in cylinder hose ports.
c.
Elbow (10) is installed closest to cylinder base
with 45° threaded end facing piston rod. Elbow
(13) is installed closest to piston rod with 900
threaded end facing cylinder base.
d. Tighten lock nuts (9 and 12).
GO TO NEXT PAGE
13-15
