TM 5-3895-373-20
12.2.
REPLACE/REPAIR FUEL SPRAY COMPONENTS - Continued.
C.
ASSEMBLE - Continued.
2.
INSTALL
PREFORMED
PACKINGS
AND
BOLT.
a.
Install
preformed
packings
(20)
onto
threaded end of cable assembly (15).
b.
Install
bolt
(19)
and
push
preformed
packings (20) into fuel spray wand until bolt
threads engage fuel spray wand body
threads.
c.
Tighten bolt (19) until snug in fuel spray
wand body. Turn bolt an additional 1/4 turn
to seat preformed packings (20) inside fuel
spray wand.
3.
INSTALL
FUEL
SPRAY
TRIGGER,
SELFLOCKING HEX NUT, AND HEX NUT
ONTO FUEL SPRAY WAND.
a.
Install self-locking hex nut (11). Thread hex
nut fully onto cable threads.
b.
Install fuel spray trigger (9) onto fuel spray
wand.
c.
Install trigger screw (7) and machine screw
(8).
d.
Pull fuel spray trigger upward until fully
raised. Install hex nut (10) until it rests
against trigger.
e.
While holding trigger up, back-off hex nut
(10) two full turns.
f.
Tighten self-locking hex nut (11) against
trigger (9) and hex nut (10).
g.
Fuel
spray
trigger
should
have
approximately 0.125 in. (3 mm) of free play
when self-locking hex nut (11) and hex nut
(10) are properly adjusted.
GO TO NEXT PAGE
12-6
