TM 5-3895-373-20
10.2.
REPLACE/REPAIR VEHICULAR BUMPER COMPONENTS - Continued.
B.
CLEAN.
1.
CLEAN
PUSH
ROLLER,
BEARING
SHAFTS, AND CLEANING SOLVENT
AND CLEANING CLOTH. STRAIGHT
HEADED PIN.
Cleaning solvent, PD680, is TOXIC
and flammable. Wear protective
goggles and gloves. Use only in a
well ventilated area. Avoid contact
with skin, eyes, and clothes, and do
not breathe vapors. Keep away from
heat or flame. Never smoke when
using solvent; the flashpoint for Type
III cleaning solvent is 200°F (93,3°C).
Failure to do so may result in injury
or death to personnel.
If personnel become dizzy while
using cleaning solvent, immediately
get fresh air and medical help. If
solvent contacts skin or clothes,
flush with cold water. If solvent
contacts eyes, flush eyes with water
and get immediate medical attention.
a.
Clean push roller and straight headed pin
with a cleaning cloth and cleaning solvent
to remove paving material buildup. Use a
wire
scratch
brush
to
remove
hard
deposits.
b.
Rinse bearing shafts in cleaning solvent to
remove dirt, old grease, and any other
foreign material.
2.
CLEAN BEARING SHAFT HEX HEAD
CAP SCREW THREADS.
Thread locking compound solvent
can cause eye damage. Wear safety
goggles/glasses when using. Avoid
contact with eyes. If solvent contacts
eyes, flush eyes with water and get
immediate medical attention.
a.
Use thread locking compound solvent to
clean threads of bearing shaft hex head
cap screws.
b.
Wipe dry with a cleaning cloth.
3.
CLEAN VEHICULAR BUMPER PIVOT
POINT AND MAIN FRAME PIVOT POINT
WITH
GO TO NEXT PAGE
10-6
