TM 5-3895-373-20
E.
INSTALL - Continued.
Do not work under vehicular bumper
supported only by overhead hoist.
Use cribbing to provide support to
vehicular bumper prior to removing
straight
headed
pin.
Vehicular
bumper may fall and cause injury or
death to personnel.
c.
Slowly raise overhead hoist to take up
slack in sling straps (8) and lift vehicular
bumper (7) off cribbing.
d.
With the help of another person, align and
install
vehicular
bumper
(7)
so
that
vehicular bumper pivot point (14) on
vehicular bumper is lined up with main
frame pivot point (13).
Antiseize compound can cause eye
damage.
Wear
safety
goggles/glasses when using. Avoid
contact with eyes. If compound
contacts eyes, flush eyes with water
and get immediate medical attention.
e.
Apply antiseize compound and
insert
straight headed pin (12) through vehicular
bumper pivot point (14) and main frame
pivot point (13).
f.
Insert hex head cap screw (11) and install
self-locking hex nut (10). Tighten hex nut
to 37 lb-ft (50 N•m).
g.
Disconnect overhead hoist (9) from sling
straps (8). Remove sling straps from
vehicular bumper (7).
GO TO NEXT PAGE
10-9
'
