TM 5-3895-373-20
7.9.
REPAIR SWITCH PANEL ASSEMBLY - Continued.
B.
INSTALL.
1.
ASSEMBLE
AND
INSTALL
EMERGENCY
STOP SWITCH.
a.
Slide contact blocks (31 and 32) together and
install lampholder (35) into contact blocks.
b.
Install lamp (34) into lampholder (35).
c.
Install voltage adapter (33) onto contact blocks
(31 and 32).
d.
Connect voltage adapter (33) and contact blocks
(31 and 32) together with operator switch (30).
e.
Install seal (29), adjustment ring (28), and bezel
gasket (27) onto operator switch (30).
f.
Install operator switch (30) into switch panel (16).
Install bezel (25).
g.
Back adjustment ring (28) to tighten emergency
stop switch (26) against switch panel (16). Install
pushbutton (24) and tighten. Refer to legend and
illustration.
2.
INSTALL SWITCH PANEL SWITCHES AND
HORN SWITCH ONTO SWITCH PANEL.
a.
Install horn switch (21) through front of switch
panel (16). Install panel seal washer (23) and
hex nut (22). Tighten hex nut. Refer to legend
and illustration.
NOTE
Switch panel (16) has tabs for correct
positioning of switches (6 through 15).
b.
Install hex nut (20). Install switches (15 through
6) through rear of switch panel (16). Install dust
and moisture boot (19), lockwashers (18), and
hex nuts (17). Refer to legend and illustration.
GO TO NEXT PAGE
7-82
