TM 5-3895-373-207.9. REPAIR SWITCH PANEL ASSEMBLY - Continued.A. REMOVE Continued.2. REMOVE SWITCH PANEL SWITCHES AND HORNSWITCH FROM SWITCH PANEL.a.Remove switches (6 through 15) from switchpanel (16) by removing hex nuts (17),lockwashers (18), and dust and moisture boots(19). Pull switches from rear of switch panel.Remove hex nuts (20). Discard lockwashers anddust and moisture boots. Refer to legend andillustration.b.Remove horn switch (21) from switch panel (16)by removing hex nut (22) and panel seal washer(23). Pull horn switch from front of switch panel.Discard panel seal washer. Refer to legend andillustration.3. REMOVE AND DISASSEMBLE EMERGENCYSTOP SWITCH.a.Unscrew and remove pushbutton (24), and bezel(25) from emergency stop switch (26).b.Pull emergency stop switch (26) from rear ofswitch panel (16) and remove bezel gasket (27).NOTEIf bezel gasket (27) requires replacement,replace entire operator switch (30). If bezelgasket is not discarded, retain for reassembly.c.Remove adjustment ring (28), and seal (29).Retain seal for reassembly.d.Pry apart locking tabs to separate operatorswitch (30), contact blocks (31 and 32), andvoltage adapter (33).e.Remove lamp (34) from lampholder (35).Remove lampholder from contact blocks (31 and32).f.Slide contact blocks (31 and 32) apart.GO TO NEXT PAGE7-80
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
