TM 5-3895-373-20
A.
REMOVE - Continued.
14.
DISASSEMBLE CASTER ASSEMBLY.
a.
Remove hex nut (119) from axle bolt
(120).
b.
Remove axle bolt (120), flat washer (121),
and caster wheel (122) from rigid wheel
mount (123).
c.
Remove sleeve bushing (124) from caster
wheel (122).
B.
CLEAN.
WARNING
Cleaning solvent, P-D-680, is TOXIC
and flammable. Wear protective
goggles and gloves. Use only in a
well ventilated area. Avoid contact
with skin, eyes, and clothes, and do
not breathe vapors. Keep away from
heat or flame. Never smoke when
using solvent; the flashpoint for Type
m cleaning solvent is 200°F (93,3°C).
Failure to do so may result in injury
or death to personnel.
If personnel become dizzy while
using cleaning solvent, immediately
get fresh air and medical help. If
solvent contacts skin or clothes,
flush with cold water. If solvent
contacts eyes, flush eyes with water
and get immediate medical attention.
1. RINSE
ALL
NON-ELECTRICAL
COMPONENTS WITH CLEANING SOLVENT.
2. USE A PUTTY KNIFE AND WIRE SCRATCH
BRUSH TO REMOVE PANEL AND DOOR
SEAL
RESIDUE
FROM
OPERATOR
CONTROL CONSOLE, ACCESS DOORS,
AND COVER PLATE.
3. DRY ALL CLEANED COMPONENTS WITH A
CLEANING CLOTH.
GO TO NEXT PAGE
7-37
