5. INSTALL CONDUIT MOUNTING FLANGE, CLAMP MOUNTING BRACKET, BRAKE SHOE, SPRING, AND HANDLE ONTO CONSOLE FRAME

6. INSTALL POWER RELAY, TERMINAL, AND CIRCUIT BREAKER ONTO RELAY MOUNTING BRACKET

TM-5-3895-373-20 Bituminous Distributor Body M918 Model D-63 Manual
Page Navigation
682

TM 5-3895-373-20 7.6 . REPAIR/REPLACE OPERATOR CONTROL CONSOLE ASSEMBLY - Continued. C. INSTALL - Continued. 5. INSTALL CONDUIT MOUNTING FLANGE, CLAMP MOUNTING BRACKET, BRAKE SHOE, SPRING, AND HANDLE ONTO CONSOLE FRAME. a. Install clamp mounting bracket (108) inside console frame (110). NOTE Conduit mounting flange is installed using two button head cap screws in the right side mounting holes. Left side cap screws secure ground wire connections during internal operator control console reassembly. b. Install conduit mounting flange (109) and secure clamp mounting bracket (108) with button head cap screws (107) in right side mounting holes. Tighten button head cap screws to 9 lb-ft (12 N.m) using hex head driver socket (Item 43, Appendix E). c. Install brake shoe (106) and shoulder screw (105). d. Install flat washer (103) onto handle (7). e. Install handle (7) through console frame. Thread handle through spring (104) and into brake shoe (106). Do not tighten handle to locked position. GO TO NEXT PAGE 7-40

Privacy Statement
Press Release
Contact