TM 5-3895-373-20
6.7.
REPLACE FAN BELT - Continued.
B.
INSTALL- Continued.
2.
TIGHTEN ALTERNATOR.
a.
Manually pull alternator (6) away from engine
block until fan belt (7) is snug.
b.
While holding alternator (6) tight against fan belt
(7),
mark
centerline
position
of
sliding
adjustment screw (3) on belt adjusting arm (2).
c.
Place a second mark 0.5 in. (13 mm) beyond
the first on belt adjusting arm (2).
d.
Using wedge block and a pry bar, pull alternator
(6) to line up second mark on belt adjusting arm
(2) with centerline of adjustment screw (3).
Tighten adjustment screw to 20 lb-ft (27 Nm).
e.
Tighten hex head cap screw (1) to 14 lb-ft (19
Nm).
GO TO NEXT PAGE
6-20