TM 5-3895-373-20
4.4. REPLACE TURBOCHARGER - Continued.
C.
INSTALL - Continued.
1.
Pour 4 to 5 fluid ozs (118 to 148 ml) of clean
engine oil through turbosupercharger inlet port.
Turn rotation assembly by hand to pass oil over
bearing surfaces.
m.
Route
oil
pipe
(28)
behind
turbosupercharger
(34)
and
align
connection points. Tighten hex nut (29)
hand tight.
n.
Install gasket (31) and hex head cap
screws (30). Tighten cap screws hand
tight.
o.
Securely tighten hex nut (29).
2.
INSTALL EXHAUST PIPE.
a.
Install gasket (27) and exhaust elbow (23)
on turbosupercharger and secure with
washers (25) and bolts (24). Orient bolts
to thread into connector flange (26) as
noted in step A.2.d.
WARNING
Anti-seize compound can cause eye
damage. Wear safety goggles/glasses
when using. Avoid contact with eyes.
If compound contacts eyes, flush
eyes with water and get immediate
medical attention.
b.
Coat exhaust elbow studs (53) with anti-
seize compound. Install gasket (19).
Attach exhaust pipe (16) to exhaust elbow
(23) using washers (18) and nuts (17).
Tighten nuts to 33 lb-ft (45 N.om).
c.
Install heatshield (22). Secure with flat
washers (21) and hex nuts (20).
GO TO NEXT PAGE
4-26
