TM 5-3895-373-20
4.4. REPLACE TURBOCHARGER - Continued.
B. CLEAN.
1.
CLEAN
TURBOSUPERCHARGER
METAL
PARTS.
WARNING
Cleaning solvent, P-D-680, is TOXIC
and flammable. Wear protective
goggles and gloves. Use only in a
well ventilated area. Avoid contact
with skin, eyes, and clothes, and do
not breathe vapors. Keep away from
heat or flame. Never smoke when
using solvent; the flashpoint for Type
III cleaning solvent is 200°F (93,3°C).
Failure to do so may result in injury
or death to personnel.
If personnel become dizzy while
using cleaning solvent, immediately
get fresh air and medical help. If
solvent contacts skin or clothes,
flush with cold water. If solvent
contacts eyes, flush eyes with water
and get immediate medical attention.
a.
Use a clean, lint-free cloth soaked with
cleaning , solvent to clean all metal parts.
b.
Use a parts cleaning brush and cleaning
solvent to remove any hard deposits and
carbon buildup.
CAUTION
Use caution when scraping gasket
sealing surfaces with putty knife.
Putty
knife
may
score
sealing
surfaces and debris may fall into
open ports. Failure to do so may
result
in
poor
seal
and
turbosupercharger damage.
c.
Use a putty knife, if necessary, to remove
any gasket material from sealing surfaces.
Do not score the sealing surface or allow
any gasket material to fall into open ports.
2.
CLEAN MOUNTING
HARDWARE
AND
THREADED FITTINGS.
a.
Using cleaning solvent, clean threads of
bolts, screws, and studs. Use a parts
cleaning
brush
to
remove
any
hard
deposits from threads.
b.
Dry with a clean, lint-free cloth.
GO TO NEXT PAGE
4-24
