TM 5-3895-373-20 C. INSTALL - Continued. 3. INSTALL TURBOSUPERCHARGER INLET HOSE   AND   TURBOSUPERCHARGER   INLET ELBOW. a. Slide hose clamp (12) onto inlet hose (13). b. Connect inlet hose (13) to turbosupercharger inlet. c. Install  compression  sleeve  (15)  onto  fuel pipe (9). CAUTION Do    not    overtighten    tube    coupling nut. Overtightening may damage compression sleeve and cause leakage. d. Connect     fuel     pipe     (9)     to cold start induction heater (7). Tighten tube coupling nut  (8).    Do  not  overtighten  tube  coupling nut. e. Install  flat  washers  (11)  and  bolts  (10) into turbosupercharger intake elbow manifold (5). f. Place    gasket    (14)    over    bolts    (10)    on turbospercharger intake elbow manifold. g. Install     turbosupercharger     intake     elbow manifold   (5)   and   gasket   (14).      Tighten bolts (10) to 9 lb-ft (12 N.m). h. Tighten hose clamp (12). i. Apply   electrical   insulating   compound   to cold     start     induction     heater     lead     wire contact  (6).    Connect  lead  wire  contact  to cold start induction heater (7). j. Connect pressure transmitter (4) to turbosupercharger   intake   elbow   manifold (5).    Apply  electrical  insulating  compound to    transmitter    harness    connector    (3). Connect transmitter harness connector. k. With  clamp   (2)   installed   on   reducer   (1), connect reducer to turbosupercharger. l. Tighten clamp (2). m. With the help of another person, set DCA test  switch  to  TEST.    Refer  to  paragraph 7.17. n. Turn engine by the starter per TM 5-3895- 373-10 until a steady flow of oil comes out of   oil   pipe   (28).   Tighten   hex   head   cap screws (30) to 16 lb-ft (22 N.m). o. Set  DCA  test  switch  to   RUN.      Refer   to paragraph 7.17. NOTE FOLLOW-ON-TASKS:   Install engine access cover per paragraph 2.22. Close front top left access door per TM 5-3895-373-10. END OF TASK 4-27