2. DISCONNECT HOSES AT EXTENSION SCREED VIBRATION MOTOR

1. DISCONNECT TUBES AT MAIN SCREED VIBRATION MOTOR

B. INSTALL - TM-5-3895-373-20_1119

TM-5-3895-373-20 Bituminous Distributor Body M918 Model D-63 Manual
Page Navigation
1110

TM 5-3895-373-20 15.12. REPLACE SCREED VIBRATION MOTORS - Continued. A. REMOVE - Continued. 2. DISCONNECT HOSES AT EXTENSION SCREED VIBRATION MOTOR. Cleaning solvent, PD680, is TOXIC and flammable. Wear protective goggles and gloves. Use only in a well ventilated area. Avoid contact with skin, eyes, and clothes, and do not breathe vapors. Keep away from heat or flame. Never smoke when using solvent; the flashpoint for Type III cleaning solvent is 200°F (93,3°C). Failure to do so may result in injury or death to personnel. If personnel become dizzy while using cleaning solvent, immediately get fresh air and medical help. If solvent contacts skin or clothes, flush with cold water. If solvent contacts eyes, flush eyes with water and get immediate medical attention. Thoroughly clean hydraulic hoses and fittings before disconnecting. Always plug or cap off disconnected fittings to prevent intrusion of contaminants. Failure to properly clean and cap off connectors may result in hydraulic system contamination and equipment damage. a. Use cleaning solvent and cleaning cloth to clean around hydraulic fittings at extension screed vibration motor (5). b. Place machinery wiping towel below hydraulic fittings on extension screed vibration motor. Hydraulic oil can be moderately flammable and can be an irritant to the skin, eyes, and respiratory system. Avoid prolonged exposure. Eye protection and rubber gloves must be worn when working with hydraulic oil. c. Tag and disconnect hoses (6 and 7) from elbows (8). Plug hoses and elbows. Discard machinery wiping towel in accordance with local procedures. GO TO NEXT PAGE 15-88

Privacy Statement
Press Release
Contact