2. INSTALL MAIN SCREED BLOWER ASSEMBLIES AND FLEXIBLE PIPE

TM-5-3895-373-20 Bituminous Distributor Body M918 Model D-63 Manual
Page Navigation
1021

TM 5-3895-373-20 E. INSTALL - Continued. 2. INSTALL MAIN SCREED BLOWER ASSEMBLIES AND FLEXIBLE PIPE. a. Connect flexible pipe (13) onto adapter (14) and place blower assembly (12) onto main screed. b. Place cushions (11) above and below blower assembly (12) and install motor mounting clamp (10). c. Install flat washer (9) onto hex head cap screw (8). Thread locking compound can cause eye damage. Wear safety goggles/glasses when using. Avoid contact with eyes. If compound contacts eyes, flush eyes with water and get immediate medical attention. d. Apply thread locking compound to hex head cap screws (8). e. Install flat washers (9) and hex head cap screws (8). Tighten cap screws evenly until motor is secure in cushions (11). f. Apply thread locking compound to the threads on clamps (7 and 29). g. Install clamps (7 and 29) and hex nuts (6 and 28). Tighten hex nuts evenly to 9 lb-ft 12 N•m). h. Apply electrical insulating compound to blower electrical connector (4). i. Connect screed harness electrical connector (5) to blower electrical connector (4). GO TO NEXT PAGE 14-71

Privacy Statement
Press Release
Contact