TM 5-3895-373-20
F.
ADJUST.
1.
START PAVING MACHINE AND SCREED
BURNER PER TM 5-3895-373-10.
2.
IF SMOKE IS SEEN COMING FROM SCREED
BURNER,
ADJUST
NOZZLE
ASSEMBLY
FOLLOWING STEPS 3, 4, AND 5. IF NO
SMOKE IS SEEN, PROCEED TO STEP 6.
Use extreme caution when working
near
operating
burner.
Wear
protective gloves and goggles when
making burner adjustment. Failure to
do so may result in severe burns to
personnel.
3.
LOOSEN HEX NUT (57). USE EXTREME
CAUTION AROUND LIT BURNER.
4.
SLIDE NOZZLE ASSEMBLY LEFT OR RIGHT
TO A POSITION WHERE THE BURNER
FLAME CREATES LITTLE OR NO BLACK
SMOKE.
5.
TIGHTEN HEX NUT (57) TO 42 lb-ft (57 N-m).
6.
TURN OFF SCREED BURNER, SHUT OFF
ENGINE, AND REMOVE KEY FROM IGNITION
SWITCH PER TM 5-3895-373-10.
NOTE
FOLLOW-ON-TASK: Extension screeds fully retracted per TM 5-3895-373-10.
END OF TASK
14-49
