TM 5-3895-373-20
B.
REPAIR Continued.
2.
CLEAN SOLENOID VALVE.
Cleaning solvent, P-D-680, is TOXIC
and
flammable.
Wear
protective
goggles and gloves. Use only in a
well ventilated area. Avoid contact
with skin, eyes, and clothes, and do
not breathe vapors. Keep away from
heat or flame. Never smoke when
using solvent; the flashpoint for Type
III cleaning solvent is 200°F (93,3°C).
Failure to do so may result in injury
or death to personnel.
If personnel become dizzy while
using cleaning solvent, immediately
get fresh air and medical help. If
solvent contacts skin or clothes,
flush with cold water. If solvent
contacts eyes, flush eyes with water
and get immediate medical attention.
a.
Clean valve body with cleaning solvent and
cleaning cloth.
b.
Use a culture swab to wipe out valve body inner
bores.
Compressed
air
used
for
cleaning
purposes will not exceed 30 psi (207
kPa)
Use
only
with
effective
chip
guarding
and
personal
protective
equipment (goggles/face shield, gloves,
etc.). Failure to take proper precautions
may result in severe injury or loss of
vision.
c.
Use 30 psi (207 kPa) maximum compressed air
to remove any foreign matter from valve body
bore, threaded surfaces, and seal grooves. Dry
valve body with a clean, lint-free cloth.
3.
ASSEMBLE SOLENOID VALVE.
a.
Install o-ring (22), plunger (21), and spring (20)
into valve body (19).
b.
Install and tighten sleeve assembly (18).
GO TO NEXT PAGE
14-53
