TM 5-3895-373-10lPlace auger/conveyor switches (31) in the down, "MAN" position.mPlace both LH and RH feeder control switches (32) in the up, ON position, and run the auger/conveyor system forone minute to distribute diesel fuel over all components of the system.nAfter one minute, place both feeder control switches (32) in the down, OFF position.The screed can fall rapidly. Do not lower the screed if anyone is near or under the screed.Falling screed can cause severe injury or death.oPlace screed lift switch (4) in the up, LIFT position and lift screed up off the ground 6 in. (152 mm).pCycle left and right extension screeds three or four times in and out using extension screed control switches (3).The screed can fall rapidly. Do not lower the screed if anyone is near or under the screed.Falling screed can cause severe injury or death.qLower screed to the ground by placing screed lift switch in the down, FLOAT position.rShut off engine and remove key from ignition switch per paragraph 2.11.sInspect areas of paving machine that come into contact with paving material and repeat washdown procedures toremove any remaining build up of paving material.3-33/(3-34 blank)
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
