TM 5-3895-373-10
SECTION III. OPERATOR MAINTENANCE INSTRUCTIONS
3.3 INTRODUCTION.
This
section
covers
maintenance
instructions
for
maintenance functions authorized to the operator by the
Maintenance
Allocation
Chart
(MAC).
Minor
adjustments, maintenance, and removal and installation
procedures are provided to assist in the efficient
operation of the paving machine.
3.3.1 Toolbox Access. The paving machine toolbox is
located on the operator platform underneath the rear top
right access door. To access the toolbox perform the
following steps.
a.
Shut off the paving machine engine.
b.
Position operator control console (1) to the left
side of the operator platform.
(1)
Turn
console
brake
handle
(2)
counterclockwise to unlock the console.
(2)
Slide console along guide shaft (3) to the
left until it stops.
(3)
Lock the console in place by turning
console brake handle clockwise.
c.
Unlock and remove toolbox padlock (4).
d.
Raise latch (5) and turn 90°, lift rear top right
access door (6).
e. Turn the latch (5) 90° and lower to lock.
3-18
