TM 5-3895-373-10
Table 3-1. Troubleshooting Table - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
6. ENGINE SPEED LOW. Refer to Table 3-2.
Check throttle control switch position.
Return throttle control switch to the desired position between MAX and IDLE per paragraph
2.1.1. If engine speed does not increase, inform supervisor of problem.
7. FUEL GAUGE READING INCORRECTLY.
Remove fuel tank cap and visually check fuel tank level.
NOTE
Fuel tank level may only be visible when the fuel tank is almost completely full. Refill fuel tank as
necessary. Inform supervisor of incorrect fuel gauge reading.
8. ALL HYDRAULIC FUNCTIONS INOPERATIVE.
Check hydraulic reservoir level.
If hydraulic oil level is low, add hydraulic oil as necessary per paragraph 3.3.4. If oil level is
OK, inform supervisor of problem.
9. HYDRAULIC FUNCTIONS OPERATE SLOWLY OR SLUGGISHLY.
Step 1. Check hydraulic reservoir level.
If hydraulic oil level is low, add hydraulic oil as necessary per paragraph 3.3.4.
Step 2. Check engine speed.
If maximum engine speed is below 2600 rpm, place the throttle control switch in the MAX
position to raise engine speed per paragraph 2.1.1. If engine speed does not increase, inform
supervisor of problem.
10. PAVING MACHINE WILL NOT MOVE.
Step 1. Check the position of the travel switch.
If travel switch is in neutral position, place the travel switch in the forward/reverse position per
paragraph 2.1.1.
Step 2. Change the position of the speed range switch.
If paving machine moves in only one speed range, inform supervisor of problem. If paving
machine will not move in either speed range, inform supervisor of problem.
3-5
