TM 5-3895-371-24 & P
g. Install Motor. (Refer to fig. 3-58.)
(1)
Mount rail (18) to hydraulic motor (17) with one capscrew (19), nut (22) and lock-
washer (21). (Do not tighten.)
(2)
Install tachometer drive housing assembly to motor (17) and rail (18) with two cap-
screws (19), lockwasher and nuts. (Do not tighten.)
(3)
Start drive coupling (25) onto shaft of hydraulic motor (17) and install tachometer
drive chain (20) onto drive coupling (25) and finish pushing drive coupling (25) into place. Install
capscrews (24) with nuts and washers (2).
(19).
(4)
Adjust tachometer drive chain (20) to a slight tension and finish tightening capscrews
(5)
Install sprocket cover (7) with two capscrews (8) and washers (8).
(6)
and nuts (16).
Install hydraulic motor (17) into place and secure with capscrews (12), washers (15),
(7)
Connect tachometer cable (5).
(8)
Connect override cable (9) to override cable clamp (11). Tighten capscrew (10), washer
(13), and nut (14).
(9)
Install capscrews (1) and nuts and washers (2).
(10)
Connect hydraulic lines (30), (31), and (32).
(11)
Install hydraulic hose (27) to elbow (26) and tee (29).
3-81
