TM 5-3895-371-24 & P
(8)
Install air supply tank with two bolts in clamp brackets (fig. 3-114).
(9)
Install two air lines to air supply tank (fig. 3-114).
(10)
Install three clamp bolts holding air lines to tank (fig. 3-106).
(11)
Install three bolts at center of fender (fig. 3-107).
(12)
Install fender to tank brace bolt (fig. 5-3).
(13)
Install control box air line (3) (fig. 4-5).
(14)
Install step to rear fender (fig. 5-3).
(15)
Install asphalt pump (para 3-7).
(16)
Install low pressure burners (para 2-39).
(17)
Install low pressure burners air inlet tube (para 2-39).
(18)
Install intake valve lever (para 2-30).
(14), and two nuts (15).
(20)
Install two smoke stacks (para 2-28).
(27)
Install eight bolts thru walkway and brackets (para 4-4).
(22)
Install fuel tank (see para 2-27 b).
(24)
Install four tank brackets to sub-frame bolts (fig. 4-11).
(25)
Install one bolt at rear of right fender brace (fig. 3-108).
(26)
Install three center fender bolts (fig. 3-107).
(27)
Install two fuel lines to tank and secure with three clamps and bolts (fig. 3-106).
nut until it just touches spring top then pull down one inch.
two screws (8).
each pair of clamps to tank with screws (5 and 7).
(37)
Install hydraulic motor. (Refer to para 3-6.)
3-100
