TM 5-3895-371-24 & P
NOTE
In step (4), two men are required to remove
the tank.
(4) Loosen mounting clamps (23) and (16) by removing one nut (21), capscrew (34) and
lockwasher (22) on top and one on bottom of each clamp; then remove hydraulic tank (24).
Hydraulic Tank Installation.
f.
(1) Mount hydraulic tank (24) into two mounting clamps (23) and (16); then tighten
clamps by installing one nut (21), capscrew (34) and lockwasher (23) on top and one on bottom of
each clamp.
(2)
Install nipple (27), pipe tee (29), plug (25) and elbow (32).
(3)
Install thermo switch (28) in hydraulic tank (24) and connect electrical wire (30).
(4)
Connect three hydraulic lines (26), (31), and (33) to hydraulic tank (24).
(5)
Install hydraulic filter as described in paragraph d.
(6)
InstalI breather (17), thermometer (18), cap (19), and oil level glass (20).
Section XIII. MAINTENANCE AND ROUTING OF HYDRAULIC LINES
2-17. Routing of Hydraulic Lines.
a.
NOTE
Plug all lines and orifices as removed.
(1)
(2)
Loosen hose clamps (3) and (7); remove hydraulic line (17).
(3)
Loosen hose clamps (5) and (12); remove hydraulic line (15).
(4)
Unscrew hydraulic fittings (1) and (9); remove hydraulic line (8).
(5)
Unscrew hydraulic fitting (2) to free hydraulic line (16) from tank (4).
(6) Remove eight bolts and washers from pipe flange blocks (14) on either side of hydraulic
pump (10); remove hydraulic lines (11) right side and (13) from hydraulic pump (10) left side.
(7) Cut nylon hose ties (21) from hydraulic line (16), along inside of LH frame rail; unscrew
fitting from 'T' at bottom of hydraulic motor (19); remove hydraulic line (16) from vehicle.
(8)
Remove hydraulic lines (11) and (13) from `U' holders (20) and (22); cut nylon ties.
(a) Remove four bolts and washers from pipe flange block at side of hydraulic motor
(19); remove hydraulic line (11) from vehicle.
(b) Remove four bolts and washers from pipe flange block at side of blower (18);
remove hydraulic line (13) from vehicle.
2-36