TM 5-3895-371-24 & P
Hydraulic Filter Disassembly. (Refer to fig. 2-12.)
b.
(1)
Unscrew center post (15) and pull out the following:
(a) Seal (14).
(b) Housing (12).
(c) Washer (1).
(d) Spring (11).
(e)
Filter element (10) with two seals (2).
(f) O-ring (9).
(2)
Unscrew indicator (6) from head (5).
(3)
Remove two bushings (4 and 7) from head (5).
(4)
Discard O-ring (9), filter element (10), and seal (14).
c.
Hydraulic Filter Assembly Reassembly. (Refer to fig. 2-12.)
(1)
Install two bushings (4 and 7) into head (5).
(2)
Install indicator (6) into head (5).
(3)
Insert spring (11), washer (1), and new filter element (10) with two seals (2) into
housing (12).
(4)
Place new O-ring (9) on head (5) and mount assembled housing (12) to head (5).
(5)
Install new seal (14) and secure assembly to head (5) with center post (15).
Hydraulic Filter Installation.
d.
(1)
Mount assembled filter assembly (35) on bracket (37) and secure with two capscrews
(38).
(2)
Connect hydraulic lines (39) and (36) to filter assembly (35) and elbows (3) and (8).
(3)
Install drain plug (25) and fill hydraulic tank (24) with hydraulic fluid, refer to LO 5-
3895-371-12.
Hydraulic Tank Removal.
e.
(1)
Remove filter and oil as described in paragraph a.
(2) Loosen fittings and remove three hydraulic lines (26), (31), and (33), (fig. 2-12) from
hydraulic tank assembly (24).
(3) Disconnect electrical wire (30) from thermo switch (28); than unscrew thermo switch
(28) from hydraulic tank assembly (24). Remove breather (17), themometer (18), cap (19), oil level
glass (20), pipe tee (29), nipple (27), and elbow (32).
2-35
