TM 5-3895-371-24 & P
Installation. (Refer to fig. 2-11.)
b.
(1) From underneath vehicle, push assembled control cable (6) up through panel. (The
panel is shown in detail on sheet 1 of illustration).
Attach control cable (6) to panel with two nuts (5) and washers (7).
(2)
Install knurled nut (4), vernier (3), nut (2) and knob (1).
(3)
(4) Screw three nuts (45) on to control cable (6) with lock assembly (47) and bellows (46).
Secure with spring body (40), spring (42), gland (43) and lock nut (44).
Push lock assembly (47) through vehicle frame and secure with nut (48).
(5)
(6) Add lock nuts (9), connector (8) and joint (12) to rod (11) and secure with washer
(13) and lock nut (9).
c.
Removal of Front Override Control. (Refer to fig. 2-11.)
(1) From underneath vehicle, disconnect chain connector from vehicle mounting bracket by
removing two screws (17), washers (15), nuts (16), two set screws in chain link (14) and (18).
(2) Remove cable (26) by removing screw (35), two screws (28), washers (37) and nuts (36).
Remove plate (27), block (38), screw (29), two washers (32) and nut (34) from arm (31).
Remove rod (23) by removing nuts (22), washers (21) and joints (19).
(3)
Remove control assembly (10) by removing lock nut and pull cable assembly (10) out.
(4)
Installation of Front Override Cable. (Refer to fig. 2-11.)
d.
(1) Push control assembly (10) through panel and secure with, lock nut. Install rod (23) with
joints (19) and secure with nuts (22) and washers (21).
(2) Install cable (26) with plate (27) and block (38). Secure with two screws (28), washers
(37) and nuts (36). Install arm (31) with screw (29), two washers (32) and nut (34). Install screw (35)
into stop (30).
(3) Attach cable to vehicle mounting bracket with set screw in chain link (14), two cap-
screws (17), washers (15) and nuts (16).
Section XII. MAINTENANCE OF HYDRAULIC TANK AND FILTER
2-16. Hydraulic Tank and Filter.
Hydraulic Filter Removal. (Refer to fig. 2-12.)
a.
NOTE
In step (1), a clean 20-gallon (76 I) container
is required.
(1) Drain oil from hydraulic tank (24) by removing one of the drain plugs (25) at bottom of
the hydraulic tank.
Disconnect hydraulic lines (39) and (36) at filter assembly (35) and remove elbows (3)
(2)
and (8).
Remove hydraulic filter assembly (35) by removing two capscrews (38).
(3)
2-33
