TM 5-3895-371-24 & P
(9) Tap in two bearing cups, one at the top and one at the bottom. Secure each bearing cup
with a lockring.
Rotate drive shaft in vise 90o and repeat step 9 above for the other two bearing cups.
(10)
Section XI. MAINTENANCE OF HYDRAULIC PUMP CONTROL
AND FRONT OVERRIDE CONTROL
2-15. Hydraulic Pump Control.
Removal. (Refer to fig. 2-11.)
a.
(1) Screw down vernier (3) to gain access to nut (2); then loosen nut (2) and remove shift-
ing knob (1).
(2)
Unscrew and remove shifting knob and nut (2), vernier (3), and knurled nut (4).
(3)
Remove two nuts (5) and washers (7) from cable (6).
(4)
From underneath vehicle, remove nut (48) that fastens lock assembly (47) to vehicle
frame.
(5) Loosen locknut (45); then unscrew spring body (40) from control cable (6). Pull out
control cable (6) with attaching parts; then remove lock nuts (45), bellows (46) and lock assembly
(47). Loosen three lock nuts (9) and remove connector (8) and joint (12).
(6)
Remove nut (44) from rod (41) and remove gland (43), spring (42) and spring body (40).
Figure 2-11. Hydraulic Pump Controls (Sheet 1 of 2).
2-31
