TM 5-3895-385-23-2
0427
Side Left Plate Removal -- Continued.
1. Remove two bolts (Figure 1, Item 7), lock washers (Figure 1, Item 8), flat washers (Figure 1, Item 9), and
floorboard gusset (Figure 1, Item 2) along with tether (Figure 1, Item 10) from floorboard (Figure 1, Item 1).
Discard lock washers.
2. Disconnect W1 J24 (Figure 1, Item 4) from left sonic auger sensor connection point (Figure 1, Item 3).
3. Disconnect W1 J36 (Figure 1, Item 6) from left system 5 connection point (Figure 1, Item 5).
4. Remove 10 bolts (Figure 1, Item 18), lock washers (Figure 1, Item 19), and flat washers (Figure 1, Item 20),
from Bituminous Material Paving Machine (BMPM) (Figure 1, Item 11). Discard lock washers.
5. Remove five bolts (Figure 1, Item 14), lock washers (Figure 1, Item 13), and flat washers (Figure 1, Item 12),
from BMPM (Figure 1, Item 11). Discard lock washers.
WARNING
The side left plate weighs 50 pounds (lb) (23 kilograms (kg)). Two personnel are necessary to lift
component. Failure to comply may cause injury or death to personnel.
CAUTION
Properly support the item being lifted. Failure to comply may cause damage to equipment.
6. Remove three bolts (Figure 1, Item 17), lock washers (Figure 1, Item 16), flat washers (Figure 1, Item 15),
and side left plate (Figure 1, Item 21) from BMPM (Figure 1, Item 11) with assistance. Discard lock washers.
END OF TASK
Side Left Plate Installation
WARNING
The side left plate weighs 50 lb (23 kg). Two personnel are necessary to lift component. Failure to
comply may cause injury or death to personnel.
CAUTION
Properly support the item being lifted. Failure to comply may cause damage to equipment.
1. Install side left plate (Figure 1, Item 21), three bolts (Figure 1, Item 17), new lock washers (Figure 1, Item 16),
and flat washers (Figure 1, Item 15) onto BMPM (Figure 1, Item 11) with assistance.
2. Install five bolts (Figure 1, Item 14), new lock washers (Figure 1, Item 13), and flat washers (Figure 1, Item
12) onto BMPM (Figure 1, Item 11).
3. Install 10 bolts (Figure 1, Item 18), new lock washers (Figure 1, Item 19), and flat washers (Figure 1, Item 20)
onto BMPM (Figure 1, Item 11).
4. Connect W1 J24 (Figure 1, Item 4) onto left sonic auger sensor connection point (Figure 1, Item 3).
