TM 5-3895-385-23-2
0426
Track Tension Hydraulic Cylinder Inspection
1. Inspect hydraulic fittings on hydraulic cylinder (Figure 1, Item 6) for cracks, stripped threading, wear, or
deformities. Replace Tee fittings if damaged.
2. Inspect hydraulic cylinder (Figure 1, Item 6) for significant scoring and pitting on cylinder shaft. Replace
hydraulic cylinder if damage is found.
3. Inspect hydraulic cylinder (Figure 1, Item 6) for evidence of leaking seals. If leaking seals are found, replace
hydraulic cylinder.
END OF TASK
Track Tension Hydraulic Cylinder Installation
1. Install new cotter pin (Figure 1, Item 4), clevis pin (Figure 1, Item 2), and track tension hydraulic cylinder
(Figure 1, Item 6) into BMPM mounting points (Figure 1, Item 3).
2. Remove caps/plugs from hydraulic hose and hydraulic fitting.
3. Connect hydraulic hose (Figure 1, Item 5) to track tension hydraulic cylinder (Figure 1, Item 6).
4. Install new cotter pin (Figure 1, Item 7) and clevis pin (Figure 1, Item 8) into track tension hydraulic cylinder
(Figure 1, Item 6) and front idler assembly (Figure 1, Item 1).
END OF TASK
FOLLOW-ON TASK
1. Verify proper operation.
2. Dispose of hydraulic oil and wiping rags In Accordance With (IAW) local Standard Operating Procedure
(SOP).
END OF TASK
END OF WORK PACKAGE
0426-3/4 blank