TM 5-3895-385-23-2
0376
Main Manifold Wiring Harness Installation -- Continued.
13. Install bolt (Figure 3, Item 7), flat washer (Figure 3, Item 8), and three ground wires (Figure 3, Item 9) onto
main manifold.
14. Connect W10 J1 (Figure 1, Item 6) to W1 J8 (Figure 1, Item 1).
15. Connect W10 J2 (Figure 1, Item 4) to W1 J38 (Figure 1, Item 3).
16. Connect W10 J5 (Figure 1, Item 5) to W1 J19 (Figure 1, Item 2).
17. Connect W10 J8 (Figure 1, Item 24) to hopper up hydraulic solenoid (Figure 1, Item 23).
18. Connect W10 J4 (Figure 1, Item 25) to auger down hydraulic solenoid (Figure 1, Item 22).
19. Connect W10 J9 (Figure 1, Item 26) to left cutoff open hydraulic solenoid (Figure 1, Item 21).
20. Connect W10 J10 (Figure 1, Item 27) to left extension out hydraulic solenoid (Figure 1, Item 20).
21. Connect W10 J11 (Figure 1, Item 28) to left tow up hydraulic solenoid (Figure 1, Item 19).
22. Connect W10 J12 (Figure 1, Item 29) to right tow up hydraulic solenoid (Figure 1, Item 18).
23. Connect W10 J13 (Figure 1, Item 30) to right cutoff open hydraulic solenoid (Figure 1, Item 17).
24. Connect W10 J14 (Figure 1, Item 31) to right extension out hydraulic solenoid (Figure 1, Item 16).
25. Connect W10 J15 (Figure 1, Item 32) to left slope up hydraulic solenoid (Figure 1, Item 15).
26. Connect W10 J16 (Figure 1, Item 33) to right slope up hydraulic solenoid (Figure 1, Item 14).
27. Connect W10 J19 (Figure 1, Item 34) to truck hitch out hydraulic solenoid (Figure 1, Item 13).
28. Connect W10 J6 (Figure 1, Item 35) to crown down hydraulic solenoid (Figure 1, Item 12).
29. Connect W10 J18 (Figure 1, Item 36) to screed down hydraulic solenoid (Figure 1, Item 11).
30. Connect W10 J17 (Figure 1, Item 37) to screed up hydraulic solenoid (Figure 1, Item 10).
END OF TASK
FOLLOW-ON TASK
1. Install cable ties where necessary.
2. Install left side cover vent (WP 0430).
END OF TASK
END OF WORK PACKAGE
0376-7/8 blank