TM 5-3895-385-23-1
0213
Table 1. Fuse Box Malfunction Troubleshooting Procedures -- Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
4. No power from W1 J9.
1. Turn BATTERY DISCONNECT
switch to the OFF position (TM
5-3895-385-10).
2. Disconnect engine remote power
wiring harness W15 J1 from
main wiring harness W1 J9 (WP
0451, Vol 3, Figure 34).
3. Turn BATTERY DISCONNECT
switch to the ON position (TM 5-
3895-385-10).
4. Measure voltage (WP 0443, Vol
1. If voltage reads a minimum of 22
3) between pin 2 and 1 on
VDC, proceed to next test.
engine remote power wiring
harness W15 J1 (WP 0451, Vol
3, Figure 34).
2. If voltage reads below 22 VDC,
proceed to next malfunction.
1. If voltage reads a minimum of 22
5. Measure voltage (WP 0443, Vol
VDC, turn BATTERY
3) between pin 3 and 1 on
DISCONNECT switch to the
engine remote power wiring
OFF position, and replace main
harness W15 J1 (WP 0451, Vol
wiring harness (WP 0373, Vol 2).
3, Figure 34).
2. If voltage reads below 22 VDC,
turn BATTERY DISCONNECT
switch to the OFF position (TM
5-3895-385-10), and replace
engine remote power wiring
harness (WP 0387, Vol 2).
5. No power to starter post.
Measure voltage (WP 0443, Vol 3)
1. If voltage reads a minimum of 22
between positive and negative
VDC, turn BATTERY
posts on starter (WP 0447, Vol 3,
DISCONNECT switch to the
Figure 22).
OFF position (TM 5-3895-385-
10), and replace engine remote
power wiring harness (WP 0387,
Vol 2).
2. If voltage reads below 22 VDC,
proceed to next malfunction.
6. Batteries not charged.
1. Disconnect batteries (WP 0357,
Vol 2).
0213-3
