TM 5-3895-373-34
2.61
REPLACE CONVEYOR CHAIN ASSEMBLY - Continued.
B.
CLEAN.
1.
CLEAN ALL REMOVED METAL PARTS.
WARNING
Cleaning solvent, P-D-680, is TOXIC and
flammable. Wear protective goggles and
gloves. Use only in a well ventilated area.
Avoid contact with skin, eyes, and clothes,
and do not breathe vapors. Keep away from
heat or flame. Never smoke when using
solvent; the flashpoint for Type III cleaning
solvent is 200°F (93,3°C). Failure to do so
may result in injury or death to personnel.
If personnel become dizzy while using
cleaning solvent, immediately get fresh air
and medical help. If solvent contacts skin or
clothes, flush with cold water. If solvent
contacts eyes, flush eyes with water and get
immediate medical attention.
a.
Rinse metal parts in cleaning solvent to remove
paving material buildup. Use a wire scratch
brush to remove hard deposits.
WARNING
Thread locking compound solvent can cause
eye damage. Wear safety goggles/glasses
when using. Avoid contact with eyes. If
solvent contacts eyes, flush eyes with water
and get immediate medical attention.
b.
Clean all fasteners coated with thread locking
compound
with
thread
locking
compound
solvent.
2.
CLEAN CONVEYOR AND COMPONENT
MOUNTING SURFACES.
a.
Clean conveyor chain assembly path and
conveyor drag plates with rags soaked in
cleaning solvent. Use a scraper and wire
scratch brush to remove hard deposits. Use a
hammer and chisel where necessary.
b.
Clean mounting surfaces of parts removed from
main frame and extension bracket with rags and
cleaning solvent Ensure threaded holes are
wiped clean of all residue.
GO TO NEXT PAGE
2-840
