TM 5-3895-373-34
E.
ASSEMBLE.
1.
NSTALL O-RINGS AND SEALS.
WARNING
Hydraulic
oil
can
be
moderately
flammable and can be an irritant to
the
skin,
eyes,
and
respiratory
system. Avoid prolonged exposure.
Eye protection and rubber gloves
must be worn when working with
hydraulic oil.
a.
Lubricate cylinder head, piston, seals, and o-
rings with clean hydraulic oil.
CAUTION
New seals and o-rings are distorted
during installation. Use care during
installation to prevent damage to
seals, o-rings, and seal grooves.
Bypass leakage can result from poor
installation.
b.
Pinch sides of compression cup (15) together to
form a C-shape. Install compression cup
carefully in one side of mating groove of cylinder
head (1), and allow opposite side to snap into
place.
c.
Pinch sides of ring wiper (14) together to form a
C-shape. Install ring wiper carefully in one side
of mating groove, and allow opposite side to
snap into place.
d.
Install packing retainer (13) and o-ring (12).
e.
Install seal (11) onto piston (7).
f.
Install packing retainers (10) on each side of
installed seal (11).
GO TO NEXT PAGE
2-831
