TM 5-3895-373-34
A.
REMOVE - Continued.
5.
REMOVE
VERTICAL
ADJUSTMENT
BLOCK
ASSEMBLY.
a.
Place machinery wiping towels below hoses (33
and 34) at inboard wall of extension screed
frame.
b.
Tag and disconnect hydraulic hoses (33 and 34).
c.
Cap elbows (35) using high pressure caps.
d.
Remove hex nuts (36) and lockwashers (37).
Remove socket head cap screws (38). Discard
lockwashers.
e.
Remove guide blocks (39) and lift brackets (40).
f.
Remove cotter pins (41) and flat washers (42).
Discard cotter pins.
g.
Start the paving machine. Raise screed as
necessary to allow for removal of clevis pins
(43). Once the pins are removed, lower screed,
shut off engine, and remove key from ignition
switch per TM 5-3895-373-10.
h.
Drive out clevis pins (43).
i.
Remove clevis (44).
NOTE
Before removing hex nuts, observe the
position of each hex nut on clevis. Hex
nuts must be oriented in same position
during reassembly.
j.
Measure the threads of clevis (44) from the top
of hex nut (45) to the end of the threaded rod.
Record this measurement. This measurement
will be used during installation.
k.
Remove hex nuts (45) and discard.
GO TO NEXT PAGE
2-803
