TM 5-3895-373-34
C.
INSTALL.
1.
INSTALL STACK VALVE.
a.
Place stack valve (158) into valve panel over
mounting holes.
b.
Install flat washer (198) onto hex head cap
screw (194).
Thread locking compound can cause
eye
damage.
Wear
safety
goggles/glasses when using. Avoid
contact with eyes. If compound contacts
eyes, flush eyes with water and get
immediate medical attention.
NOTE
It may be necessary to connect hydraulic
tubes to stack valve ports per step n
before
hex
head
cap
screws
are
tightened.
c.
Apply thread locking compound to threads of hex
head cap screw (194) and insert through stack
valve (158).
d.
From underneath panel, install flat washers
(197), lockwashers (196), and hex nuts (195).
e.
Install ground wire lead (191), flat washer (192),
and ground wire lead (193) onto hex head cap
screw (187). Apply thread locking compound to
threads of cap screw and insert cap screw
through stack valve mounting hole.
f.
From underneath panel, install flat washer (190),
lockwasher (189), and hex nut (188). Tighten
hex nuts (188 and 195) to 9 Ib-ft (12 N•m).
Electrical insulating varnish fumes can
be harmful if inhaled. Use only in a well
ventilated
area.
Avoid
prolonged
exposure to fumes. If personnel
become dizzy or drowsy during use, get
immediate medical attention.
g. Apply electrical insulating varnish to ground wire
leads (191 and 193) and hex head cap screw
(187).
GO TO NEXT PAGE
2-763
