TM 5-3895-373-34
2.48
REPAIR AUGER/CONVEYOR SPEED CONTROL VALVE - Continued. am
A.
DISASSEMBLE - Continued.
4.
DISASSEMBLE AUGER/CONVEYOR SPEED
CONTROL VALVE.
a.
Remove spring caps (20), springs (21), and
balls (22) from adapter (23).
b.
Remove adapter (23) from valve body (24).
c.
Remove set screw (25) from detent ring
(26) and remove detent ring.
NOTE
It is only necessary to remove the roll
pin if damaged.
d.
Remove roll pin (27) from adapter (23).
Discard roll pin.
e.
Remove preformed packing (28)
from
adapter (23). Discard preformed packing.
f.
Unscrew and remove
rivet
(29)
from
adapter (23).
Use caution when removing seals
and o-rings. Scratched or dented
seal
grooves
can
cause
bypass
leakage. Do not use excessive force
when removing seals and o-rings.
Use an o-ring tool to remove seals
and o-rings.
g.
Use an o-ring tool and remove o-ring (30)
and packing retainer (31) from adapter
(23). Discard o-ring and packing retainer.
h.
Remove plug (32), spool (33), and spring
(34) from valve body (24).
i.
Remove o-ring (35) from plug (32). Discard
o-ring.
GO TO NEXT PAGE
2-652
