TM 5-3895-373-34
2.39.
REPAIR TRACK TENSIONING CYLINDER - Continued
This task covers:
a.
Disassemble
b.
Clean
c.
Inspect
d.
Assemble
INITIAL SETUP
Tools:
References:
General mechanic’s automotive tool kit
TM 5-3895-373-24P
(Item 106, Appendix D)
Bench vise (Item 112, Appendix D)
Equipment Condition:
O-ring tool (Item 103, Appendix D)
Track tensioning cylinder removed per paragraph 2.37.
Plastic hammer (Item 49, Appendix D)
Spanner wrench (Item 95, Appendix D)
Wire scratch brush (Item 13, Appendix D)
Materials/Parts:
Cleaning cloth (Item 6, Appendix B)
Cleaning solvent (Item 31, Appendix B)
Crocus cloth (Item 4, Appendix B)
Hydraulic oil (Item 21, Appendix B)
Lint-free cloth (Item 7, Appendix B)
Pipe sealant (Item 27, Appendix B)
Seal kit
NOTE
There is a left hand and a right hand track tensioning
cylinder. The repair procedure for the cylinders are
identical. Place of fittings are shown in the procedures.
GO TO NEXT PAGE
2-535
