TM 5-3895-373-34
E.
ASSEMBLE - Continued.
2.
ASSEMBLE TRACK TENSIONING RELIEF VALVE.
a.
Ensure that valve body (28) is completely dry
and free of all contaminants.
Thread locking compound can cause
eye
damage.
Wear
safety
goggles/glasses when using. Avoid
contact with eyes. If compound contacts
eyes, flush eyes with water and get
immediate medical attention.
b.
Apply
a
thin
coating
of
thread
locking
compound to valve seat (27).
Ensure that thread locking compound
does not plug the port opening on the
valve body. Relief valve failure and
hydraulic system failure could result.
c.
Install valve seat (27) into valve body (28) and
allow to dry for a minimum of 5 hours. Ensure
that thread locking compound does not plug the
port opening.
d.
Install check ball (26) and spring (25).
e.
Install
adjusting
screw
(22)
and
set
to
measurement A taken during disassembly.
f.
Install flat washer (24) and hex nut (23).
Ensure that adjusting screw (22) does not
move when tightening the hex nut.
g.
Install flat washer (21) and cap nut (20).
GO TO NEXT PAGE
2-531
