TM 5-3895-373-34
C.
INSTALL - Continued.
g.
Align mounting holes in front engine mounting
brackets
(195),
flywheel
housing
mounting
brackets (194), and pump drive gearbox support
brackets (193) with engine mounts (204) and
shock mounts (201).
NOTE
It may be necessary to use overhead
hoist and a pry bar to pry on support
and mounting brackets attached to
engine and pump assembly in order
to get support and mounting brackets
over hex head cap screws in engine
mounts.
h.
Lower engine and pump assembly (190) onto
engine mounts (204) and over hex head cap
screws (202). Ensure support and mounting
brackets are seated squarely on shock mounts
(201) and hex head cap screws are positioned to
secure support and mounting brackets to engine
mounts. Use overhead hoist or a pry bar to pry
on support and mounting brackets to seat
squarely on engine mounts and align with hex
head cap screws.
NOTE
Right side support and mounting
brackets attached to pump drive
gearbox and flywheel housing can be
accessed
through
engine
access
cover in hopper.
i.
Install flat washers (192), and self-locking hex
nuts (191) on hex head cap screws (202)
securing pump drive gearbox support brackets
(193) and flywheel mounting brackets (194) on
both left and right sides of the engine and pump
assembly. Access the right side support and
mounting brackets through the engine access
cover.
GO TO NEXT PAGE
2-125
