TM 5-3895-373-34
2.69
REPLACE/REPAIR AUGER/CONVEYOR MOTOR AND DRIVE SPROCKET WHEEL - Continued.
F.
INSTALL - Continued.
11.
REPLACE COVER.
a.
Turn cover (7) sideways and place under
cowling frame mounting holes.
Thread locking compound can cause eye
damage. Wear safety goggles/glasses when
using. Avoid contact with eyes. If
compound contacts eyes, flush eyes with
water and get immediate medical attention.
b.
Close rear top left access door (3).
c.
Apply thread locking compound to threads
of socket head cap screw (4) and install
through cowling frame and cover mounting
holes.
d.
Install flat washer (5) and hex nut (6).
Tighten hex nut snug.
e.
Open rear top left access door (3) and
close rear top right access door (8).
f.
Apply
thread
locking
compound
to
remaining socket head cap screw (4) and
install.
g.
Install flat washer (2) onto hex head cap
screw (1). Apply thread locking compound
to threads of hex head cap screw.
h.
Open rear top right access door (8).
i.
Install hex head cap screws (1) with flat
washers (2) through cowling frame and
cover mounting holes. Tighten cap screw
to 90 lb-ft (122 N•m).
j.
Tighten socket head cap screws (4) to 37
lb-ft (50 N•m).
NOTE
FOLLOW-ON-TASKS: Install field relay per TM 5-3895-373-20.
Replace screed per TM 5-3895-373-20.
Rear top left access door closed per TM 5-3895-373-10.
Rear top right access door closed per TM 5-3895-373-10.
Center top left access door closed per TM 5-3895-373-10.
Center top right access door closed per TM 5-3895-373-10.
END OF TASK
2-1008
