TM 5-3895-373-20 11.2. REPAIR ACCESS DOORS AND COVERS - Continued B. INSTALL - Continued. 6. INSTALL    HINGED    ACCESS    DOORS AND HINGES. Thread    locking    compound    solvent can  cause  eye  damage.    Wear  safety goggles/glasses  when  using.    Avoid contact with eyes.  If solvent contacts eyes,  flush  eyes  with  water  and  get immediate medical attention. a. Clean   threads   of   hex   head   cap   screws (18) with thread locking compound solvent.  Wipe dry with a cleaning cloth. b. Install flat washers (19) onto hex head cap screws (18). Thread locking  compound  can  cause eye damage. Wear safety goggles/glasses  when  using.    Avoid contact    with    eyes.        If    compound contacts  eyes,  flush  eyes  with  water and get immediate medical attention. c. Apply thread locking compound to threads of hex head cap screws (18). d. Position hinge blocks (20) and, if removed, hinge shims (21). e. Secure   with   flat   washers   (19),   and   hex head   cap   screws   (18).         Tighten   cap screws to 9 lb-ft (12 N•m). f. Position    access    door    (14)    on    paving machine.      Have  a  second  person  hold access    door    in    place    while    installing hinges onto door. g. Assemble dowel pins (17) and hinges (16) with hinge blocks (20). Before tightening access door hardware,     position     and     center     in opening.        If    access    door    is    not installed properly, access door misalignment and possible equipment damage could occur. h. Hold  access  door  (14)  in  position  against hinges (16).  Install and finger tighten bolts (15). i. Carefully  lower  access  door  (14)  into  the closed position and check door alignment. Door  should  be  centered  in  opening.    If necessary,   loosen   bolt   (15)   and   adjust door   position.      When   door   is   aligned, tighten bolt. j. Close   applicable   access   doors   per   TM 5389537310. END OF TASK 11-12