TM 5-3895-373-20
B.
INSTALL Continued.
2.
INSTALL HORN.
NOTE
Install horn at an angle to keep
rainwater from entering.
a.
Install horn (10), ground wire (12), flat washer
(11), and bolt (9).
b.
Install self-locking hex nut (8). Tighten nut to 19
lb-ft (26 N•m).
Electrical insulating varnish fumes
can be harmful if inhaled. Use only in
a
well
ventilated
area.
Avoid
prolonged exposure to fumes. If
personnel become dizzy or drowsy
during use, get immediate medical
attention.
c.
Apply electrical insulating varnish to ground wire
(12) connection.
Adhesive is TOXIC and extremely
flammable. Keep away from heat,
sparks, and open flames. Use only in
well ventilated areas. Do not breathe
vapors or swallow and avoid contact
with eyes and skin. Failure to do so
may result in injury or death to
personnel.
If personnel become dizzy while
using adhesive, immediately get fresh
air
and
medical
attention.
If
personnel swallow adhesive, do not
induce vomiting. Get immediate
medical
attention.
If
adhesive
contacts eyes, flush eyes with water
for 15 minutes and get immediate
medical
attention.
If
adhesive
contacts skin, wash thoroughly with
soap and water.
d.
Apply adhesive to back of sound foam (7) and
place over self-locking hex nut (8).
GO TO NEXT PAGE
7-137
