4. REMOVE ALTERNATOR

3. DISCONNECT ALTERNATOR FROM TOP BRACKET

TM-5-3895-373-20 Bituminous Distributor Body M918 Model D-63 Manual
Page Navigation
649

TM 5-3895-373-20 A. REMOVE - Continued. 4. REMOVE ALTERNATOR. a. Remove self-locking hex nut (20), ground wire (23), and washer (24). Discard self-locking hex nut. b. While supporting alternator (22), remove pivot bolt (19) and bushing blank (25). Lift alternator (22) from bottom bracket. c. If necessary, remove sleeve spacer (26). Tap spacer out with a hammer. 5. REMOVE ALTERNATOR PULLEY AND FAN. a. Remove hex nut (27) and lockwasher (28). Discard lockwasher. b. Remove alternator pulley (29) and fan (30). B. INSTALL. 1. INSTALL ALTERNATOR FAN AND PULLEY. a. Install alternator fan (30) and pulley (29). b. Install lockwasher (28) and hex nut (27). Tighten hex nut to 51 lb-ft (69 N•m) while holding shaft with alien key. GO TO NEXT PAGE 7-7

Privacy Statement
Press Release
Contact